Evco EPK4LHX Hardware manual Manual de usuario descargar pdf (Pagina 28)

EVCO S.p.A. c-pro 3 NODE kilo | Hardware manual ver. 1.0 | Code 114CP3NKE104

page 28 of 44

6.5.3 Configuration parameters of the "CAN Bus" sub-menu of the "Networks" menu

The following table shows the meaning of the configuration parameters of the "CAN Network" section of the "CAN Bus" sub-menu or the

"Networks" menu.

PARAM. MIN. MAX. M. U. DEF. DESCRIPTION

MyNode 1 127 - - - 1 local CAN node or device address

Master - - - - - - - - - YES

enabled to function as master in a CAN network

YES

= yes

Baud - - - - - - - - - 20K

baud rate of the CAN-type communication

20K

= 20.000 baud

50K

= 50.000 baud

125K

= 125.000 baud

500K

= 500.000 baud

Timeout 1 60 s 5

remote CAN-type communication timeout, i.e., communication

with the other network elements (after the time set with this

parameter has elapsed with no CAN-type communication with an

element, the element is disabled).

Network

Node

[1] 0 [32] 127 - - - [1] 99

address of the CAN nodes or of the other network elements (e.g.

for [1] 2)

[1]

= node

= node address

TSEG1 - - - - - - - - - - - - reserved

TSEG2 - - - - - - - - - - - - reserved

SJW - - - - - - - - - - - - reserved

BTR - - - - - - - - - - - - reserved

Status parameter available in read-only mode

CAN machine status

INIT

= initialisation

STOPPED

= stop CAN

OPERAT

= operating

PRE-OP

= in pre-operating mode

Bus Status parameter available in read-only mode

CAN bus status

= status OK

WARNING

= attention

PASSIVE

= bus in receiving mode only

BUS OFF

= bus stopped

Cnt Rx parameter available in read-only mode number of packets received

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Comentarios a estos manuales

Sin comentarios

Evco EPK4LHX Hardware manual Manual de usuario Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Evco EPK4LHX Hardware manual